This 2007 GMC Yukon came in with multiple complaints among which were the engine seemed to have no power, the Service Engine Soon, ABS and Traction lights were on and there was a stability message displayed in the Driver’s Information Center (DIC). The customer also stated that the vehicle ran fine sometimes but as soon as the … Continue reading “2007 GMC Yukon Multiple Misfires-Codes-P0300-P0352-P0354-P0356-P0358”
This 2008 GMC Yukon came in with the complaint of reduced power and the vehicle could not be driven over about 35 mph. There were a lot of codes stored but the only one of real relevance was Code P0641 Symptom 00, 5 volt reference circuit 1. I looked at data under the TAC section … Continue reading “2008 GMC Yukon, Reduced Power Mode, Code P0641 00 Stored”
This 2006 GMC Yukon came in with the Service Engine Soon (SES) light on and a code P0449 stored in the PCM memory. This test should be done on the vehicle but I could not figure a way to o the test and position everything for a good picture. So you will just have to … Continue reading “2006 GMC Yukon, P0449”
This 2005 GMC Sierra came in with a poor run condition and multiple misfire codes stored. Code P0304 was one of the misfire codes stored. While looking at data I noted that misfires on cylinder #4 were markedly higher that most of the other cylinders. Normally when confronted with high misfire counts on this engine … Continue reading “2005 GMC Sierra, Multiple Misfires”
This 2000 Chevrolet Suburban came in with the complaint that the instrument cluster does not work. I checked communication with my Tech 2 scan tool and found a communication problem with most modules. Including the instrument cluster. Since my scan tool would power up, I knew that I had power to the DCL and at … Continue reading “2000 Chevrolet Suburban, Instrument Cluster Does Not Work”
This 2003 Chevrolet Avalanche with a 5.3 liter VIN “T” engine was towed in with the complaint that the engine would not run. I went to check codes and data and found that communication to the PCM was down. I checked all of the fusees under the hood and in the interior fuse box. No … Continue reading “2003 Chevrolet Avalanche, No Run Condition”
This 2004 Chevrolet Tahoe came in with a multitude of complaints. Some of the complaints were that it might not start, the power windows would stop working, the door locks would cycle, the radio would stop working, the instrument cluster gauges would stop working and multiple warning lights would come on. From a technical perspective … Continue reading “2004 Chevrolet Tahoe Multiple Problems, No Communication”
This 1999 Chevrolet Tahoe came in with a complaint that the ECM 1 fuse in the under hood fuse box would blow, which of course causes a no run condition. Usually five to ten minutes after a cold start. That in itself is enough of a clue to me to start looking around the exhaust … Continue reading “1999 Chevrolet Tahoe, ECM 1 Fuse Blows”
This 1995 Chevrolet Pick up came in with a complaint that the engine would start running poorly. Bucking and jerking intermittently and just generally carrying on is what the customer stated. He also said that he has had several different shops look at the problem, he has spent a lot of money and I am … Continue reading “1995 Chevrolet Pickup, Runs Poorly Sometimes – Code 15”
A 2001 Chevrolet 2500HD with a 8.1 liter engine came in with the complaint that the engine would stall. Sometimes it would restart right away and sometimes it would not. I checked codes and found a code P0335 stored for a crank sensor fault. I did a basic inspection for anything obvious and found nothing … Continue reading “P0335, 2001 Chevrolet Silverado 2500HD”