This 2007 Chevrolet Monte Carlo SS came in with multiple complaints including the Emissions 1 fuse blowing in the underhood fuse box. Also there were several codes being set in the PCM as a result, P0030, P0036, P0053, P0054 and P0443. All can be related back to the blown Emissions 1 fuse. Because the Emissions … Continue reading “2007 Chevrolet Monte Carlo SS Emissions 1 Fuse Blows”
This 2007 Chevrolet Tahoe came in with the complaint that the cruise control had been not working at times but now the situation had changed to not working at all. With or without a scan tool this is a very easy diagnosis. Checking the engine codes there was a code P0573 00 for a fault … Continue reading “2007 Chevrolet Tahoe Cruise Control Does Not Work”
This 2007 GMC Yukon came in with multiple complaints among which were the engine seemed to have no power, the Service Engine Soon, ABS and Traction lights were on and there was a stability message displayed in the Driver’s Information Center (DIC). The customer also stated that the vehicle ran fine sometimes but as soon as the … Continue reading “2007 GMC Yukon Multiple Misfires-Codes-P0300-P0352-P0354-P0356-P0358”
This 2008 GMC Yukon came in with the complaint of reduced power and the vehicle could not be driven over about 35 mph. There were a lot of codes stored but the only one of real relevance was Code P0641 Symptom 00, 5 volt reference circuit 1. I looked at data under the TAC section … Continue reading “2008 GMC Yukon, Reduced Power Mode, Code P0641 00 Stored”
This 2008 Chevrolet Silverado came in with the complaint that the cruise control would not work. Since I have a Tech 2 scan tool I decided to look for codes first. There was a PCM code P0573 stored for the “Brake Switch Circuit 1 High Voltage”. Simply put the computers think that the brake lights … Continue reading “2008 Chevrolet Silverado, Cruise Control Does Not Work, P0573”
This 2006 GMC Yukon came in with the Service Engine Soon (SES) light on and a code P0449 stored in the PCM memory. This test should be done on the vehicle but I could not figure a way to o the test and position everything for a good picture. So you will just have to … Continue reading “2006 GMC Yukon, P0449”
This 2005 GMC Sierra came in with a poor run condition and multiple misfire codes stored. Code P0304 was one of the misfire codes stored. While looking at data I noted that misfires on cylinder #4 were markedly higher that most of the other cylinders. Normally when confronted with high misfire counts on this engine … Continue reading “2005 GMC Sierra, Multiple Misfires”
This 1997 Chevrolet K1500 pick up came in with the speedometer, tach and shift indicator not working sometimes. In testing I also found that there were codes stored related to the TCC (Torque Convertor Clutch) and transmission. P0740, P0785 and P1860. This is a pretty common problem but I was looking for a quick simple … Continue reading “1997 Chevrolet K1500 Pick Up, Tach and Speedometer Inoperative”
This 2004 Chevrolet Tahoe came in with the SES light on and complaints of poor fuel economy and a “strange feel to the engine”. I checked codes and found a code P0178 stored along with misfire and lean codes. P0178 is set if the frequency reading in the fuel composition sensor is below 45 Hz … Continue reading “2004 Chevrolet Tahoe, Code P0178”
A 2001 Chevrolet 2500HD with a 8.1 liter engine came in with the complaint that the engine would stall. Sometimes it would restart right away and sometimes it would not. I checked codes and found a code P0335 stored for a crank sensor fault. I did a basic inspection for anything obvious and found nothing … Continue reading “P0335, 2001 Chevrolet Silverado 2500HD”