This 2009 Chevrolet Silverado came in with the complaint that the a/c was blowing out hot air on the driver’s side of the dash.The vent temperature was 140°F and the outside air temperature was 97°F in August in sunny South Carolina. I told the customer that I would not be able to get to it … Continue reading “2009 Chevrolet Silverado Driver’s Side Air Stuck On Heat”
This 2007 Chevrolet Monte Carlo SS came in with multiple complaints including the Emissions 1 fuse blowing in the underhood fuse box. Also there were several codes being set in the PCM as a result, P0030, P0036, P0053, P0054 and P0443. All can be related back to the blown Emissions 1 fuse. Because the Emissions … Continue reading “2007 Chevrolet Monte Carlo SS Emissions 1 Fuse Blows”
This 2007 Chevrolet Tahoe came in with the complaint that the cruise control had been not working at times but now the situation had changed to not working at all. With or without a scan tool this is a very easy diagnosis. Checking the engine codes there was a code P0573 00 for a fault … Continue reading “2007 Chevrolet Tahoe Cruise Control Does Not Work”
This 2007 GMC Yukon came in with multiple complaints among which were the engine seemed to have no power, the Service Engine Soon, ABS and Traction lights were on and there was a stability message displayed in the Driver’s Information Center (DIC). The customer also stated that the vehicle ran fine sometimes but as soon as the … Continue reading “2007 GMC Yukon Multiple Misfires-Codes-P0300-P0352-P0354-P0356-P0358”
This 2004 Chevrolet Tahoe came in with the complaint that the a/c was not cold due to the compressor not coming on. Whenever the a/c was turned on the snowflake on the digital display would flash. This Tahoe has auto a/c controls. I checked codes with my Tech 2 scan tool and there was a … Continue reading “2004 Chevrolet Tahoe, Compressor Will Not Turn On”
This 2008 GMC Yukon came in with the complaint of reduced power and the vehicle could not be driven over about 35 mph. There were a lot of codes stored but the only one of real relevance was Code P0641 Symptom 00, 5 volt reference circuit 1. I looked at data under the TAC section … Continue reading “2008 GMC Yukon, Reduced Power Mode, Code P0641 00 Stored”
This 2008 Chevrolet Silverado came in with the complaint that the cruise control would not work. Since I have a Tech 2 scan tool I decided to look for codes first. There was a PCM code P0573 stored for the “Brake Switch Circuit 1 High Voltage”. Simply put the computers think that the brake lights … Continue reading “2008 Chevrolet Silverado, Cruise Control Does Not Work, P0573”
This 2006 GMC Yukon came in with the Service Engine Soon (SES) light on and a code P0449 stored in the PCM memory. This test should be done on the vehicle but I could not figure a way to o the test and position everything for a good picture. So you will just have to … Continue reading “2006 GMC Yukon, P0449”
This 2004 Chevrolet Silverado came in with the complaint that the air only blows through the defrost and will not blow out of any other location. There were codes B0263 and B3770 stored in the HVAC module. The codes refer to mode actuator faults. To access the actuator, the driver’s side heater floor vent extension … Continue reading “2004 Chevrolet Silverado, Changing The Mode Actuator”
This 2005 GMC Sierra came in with a poor run condition and multiple misfire codes stored. Code P0304 was one of the misfire codes stored. While looking at data I noted that misfires on cylinder #4 were markedly higher that most of the other cylinders. Normally when confronted with high misfire counts on this engine … Continue reading “2005 GMC Sierra, Multiple Misfires”