Well, I got to see something new today. The customer brought this 1998 Chevy K1500 in with the complaint that the right rear turn signals would not work with the park lights on. I thought no big deal, the right rear socket board has weak internal ground. Seen it a hundred times if I have … Continue reading “1998 Chevrolet K1500, Right Rear Turn Signal Erratic”
This 1996 Honda Accord came in with inoperative turn signals. The car had been in a minor front end collision. The customer had looked for the turn signal fuse and could not find it. It is in the fuse box on the driver’s kick panel. It is kind of hard to see when you are … Continue reading “1996 Honda Accord, Fuse Location For Turn Signals”
This 1997 Chevrolet C1500 pickup came in with the complaint that the park or tail light fuse would blow. i did a quick inspection of the trailer wiring at the rear of the vehicle and all was well back there. I turned my attention to the front park lights. Four phillips headed screws and it … Continue reading “1997 Chevrolet C1500 Pickup, Park Light Fuse Blows”
This 2002 Oldsmobile Bravada came in with the complaint the that driver’s side tail light was not working. A little disassembly and the problem was quite evident. Water intrusion had damaged the harness connector and the socket circuit board assembly. In the following picture you can see that the terminal on then far right side … Continue reading “2002 Oldsmobile Bravada, Tail Lights Inop”
On the previous post I had already removed the turn signal switch shown below. To view that post click here. I placed the switch in a clean secure location because I did not know what might pop out of it. I have never had one of these apart before. I flipped it over and found … Continue reading “2001 Pontiac Grand Am, Fixing The Turn Signal Switch”
This 2001 Pontiac Grand Am came in with the complaint that there was a ticking noise that continued after the turn signals switched off. I knew that the hazard switch on this car had already been replaced so I was pretty sure it was not the problem. I decided to look at the turn signal … Continue reading “2001 Pontiac Grand Am, Turn Signals Click After Switch Is Off”
1995 Chevrolet Monte Carlo changing the turn signal switch due to inop stoplights. To view diagnostics for this repair please click here. The first step is to disable and remove the air bag assembly according to manufacturers guidelines. If you do not have a manual you can purchase from either Mitchell or AllData. There are … Continue reading “1995 Chevrolet Monte Carlo, Changing The Turn Signal Switch”
This 1995 Chevrolet Monte Carlo came in with the complain that the brake / stop lights do not work. As long as all of the bulbs are working this is easy to test. First confirm that the stop lights in fact do not work. Then check the turn signals and hazard lights. If they work … Continue reading “1995 Chevrolet Monte Carlo, No Brake Lights”
This 2002 GMC Yukon came in with the complaint that the lights on the rear of the truck were working sometimes and sometimes not. The customer had only complained about the turn signals but in testing I found that different lights on both sides were not working properly. I figured it had to be a … Continue reading “2002 GMC Yukon, Tail , Stop, Turn and Reverse Lights Inop”
This 2002 Ford F250 came in with the complaint that the turn signals did not work at the trailer pigtail connector. The turns signals on the truck worked okay. Well after examining a wiring diagram I found that fuse number 6 in the interior fuse box supplies power to the right and left, trailer tow … Continue reading “2002 Ford F250, No Trailer Turn Signals”