It Recently came to my attention that some of my readers wanted to see how to perform an actuator recalibration using a Tech 2 scan tool. The pictures are dark and they are best viewed in low light conditions. Connect the scan tool to the DLC and turn the ignition on. After entering the year,make, … Continue reading “GM “C/K” & “S/T” Vehicles, HVAC Recalibration Using a Tech 2 Scan Tool”
It was time for me to replace worn out tires on my 2003 Chevrolet Silverado and I wanted to also update the look with new wheels. I wanted to stick with factory wheels, just newer. I located a company, Alan’s Wheels near Greenville, SC that handles a lot of late model take-offs on many makes and … Continue reading “Updating the Wheels & Tires, 2003 Chevrolet with 2014 Silverado LTZ Take Offs”
This 2005 Chevrolet Silverado came in with the complaint that it did not have cruise control. The customer, whom I have known for a long time, asked if I thought cruise control could be added to his truck. I was not sure. He stated that he had found several references to doing just that with … Continue reading “2005 Chevrolet Silverado, Adding Factory Cruise Control”
This 2006 GMC Yukon came in with the Service Engine Soon (SES) light on and a code P0449 stored in the PCM memory. This test should be done on the vehicle but I could not figure a way to o the test and position everything for a good picture. So you will just have to … Continue reading “2006 GMC Yukon, P0449”
This 2003 Chevrolet Silverado came in with the complaint that the blower did not work on any speed. The ABS and Brake lights were on as well. Testing begins at the HVAC fuses in the driver’s side fuse box that is located behind the dash end cap. The fuses need to be checked with the … Continue reading “2003 Chevrolet Silverado, Blower Does Not Work On Any Speed”
This 2000 Chevrolet Suburban came in with the complaint that the instrument cluster does not work. I checked communication with my Tech 2 scan tool and found a communication problem with most modules. Including the instrument cluster. Since my scan tool would power up, I knew that I had power to the DCL and at … Continue reading “2000 Chevrolet Suburban, Instrument Cluster Does Not Work”
This is a list of procedures to replace the multiple actuators on General Motors Trucks and SUV’s from 1999 to 2009. These posts will apply to all of the Full Sized Trucks and SUV’s listed below. There may be slight differences between brands and trim levels. HVAC Calibration Procedure GM Trucks And SUV’s 2003 Chevrolet … Continue reading “Actuator Replacement GM Trucks and SUV’s 1999-2009”
This 2002 Chevrolet Tahoe had several complaints and this one is no fog lights. I connected my Tech 2 scan tool and checked some basic functions and found that the scan tool could turn on the fog lights. There was a codes stored for a park light malfunction. I checked wiring diagrams and found that … Continue reading “2002 Chevrolet Tahoe, Fog Lights Do Not Work”
This 2005 GMC Sierra came in with the complaint that the air will only flow from the defroster vents, regardless of where it is commanded to. This Sierra has auto a/c controls and no floor mounted center console. Of course the customer brought the truck in, knowing that I had to lay under the driver’s … Continue reading “2005 GMC Sierra, Air Blows Only From Defroster Vents”
This 2004 Chevrolet Silverado came in with a faulty passenger side blend door actuator. In the last post I got you to this point. If you have not yet read that post please click here. Now that the dash cover is off and you can see the actuator, but you still cannot get to it. … Continue reading “2004 Chevrolet Silverado, Changing The Passenger Side Blend Door Actuator, B0424”