This 2014 GMC Enclave came in with the complaint that the engine would fail to start sometimes and occasionally stall while driving. Multiple warning lights would come on in the dash. I checked codes and found codes P0689 and P1682 stored in the PCM. In researching the codes I found a GM TSB #19-NA-276 I … Continue reading “2014 GMC Acadia, Stalls Sometimes, Codes P0689 and P1682”
This 2017 Buick Enclave came in with the complaints that the a/c would stop and a “message” would appear in the dash. It took a few times checking this problem out for the problem to actually occur. There were no codes stored in the pcm related to the charging system. There were however low voltage … Continue reading “2017 Buick Enclave Alternator Stops Charging”
This 2006 Buick Lucerne came in with the complaint that the engine would run hot sometimes. The cooling fans had been replaced with used parts and the coolant reservoir had also been replaced. The customer had stated that someone told them that the oxygen sensor could be causing the problem. I told him that I … Continue reading “2006 Buick Lucerne-Runs Hot”
This 2005 Buick Century came in with the complaint that sometimes the engine would not start and using the turn signals would cause the engine to stall. It belongs to a local used car lot and they did not tell me all of this. Had to figure it out on my own over several days. … Continue reading “2005 Buick Century, Hard Crank No Run Condition”
This vehicle came in with the complaint that the blower motor would work sometimes but recently it had gotten to where it did not work at all. I hardly ever see vehicles this old in my shop anymore. This is one problem that I have fixed dozens if not hundreds of times over the years … Continue reading “GM Cars & Trucks 1960’s, 1970’s & 1980’s, Blower Inoperative Erratic”
This 2008 Buick Enclave CXL came in with the complaint that the battery would go dead while driving. The battery light was on and there was a message on the dash to service the charging system. Something else that I noticed but cannot duplicate here is that there was a steady moan from the engine … Continue reading “2008 Buick Enclave Replacing The Alternator”
This 2010 Buick Enclave CXL came in with the complaint that the a/c is not as cold as it should be during the heat of the day. The problem is that with the ambient temperature being 98° F and the heat index at 112°F the best the vent temperature would drop to was the mid … Continue reading “2010 Buick Enclave CXL, A/C Does Not Cool Well”
This 2006 Chevrolet Trailblazer came in with the complaint that the blower would not work after the blower resistor had been replaced. This Trailblazer clearly has manual HVAC controls. However the customer was sold the wrong part or asked to buy the wrong part. I do not know which for sure. The part on … Continue reading “2006 Chevrolet Trailblazer, Blower Does Not Work After Resistor Replacement”
This 2007 GMC Envoy Denali came in with the complaint that the blower motor would not work. The customer stated that they had removed the blower motor and connected it to battery voltage and ground. The blower motor worked under this condition. This vehicle also has auto temperature controls as indicated by a digital display. … Continue reading “2007 GMC Envoy Denali, Blower Does Not Work On Any Speed”
It Recently came to my attention that some of my readers wanted to see how to perform an actuator recalibration using a Tech 2 scan tool. The pictures are dark and they are best viewed in low light conditions. Connect the scan tool to the DLC and turn the ignition on. After entering the year,make, … Continue reading “GM “C/K” & “S/T” Vehicles, HVAC Recalibration Using a Tech 2 Scan Tool”