- HVAC recalibration issue
I was getting warm air from driver side and cool from passenger side. I performed the hvac recal. as described…
- Where is the TCM located
2 door with hatch doors. I believe it is referred as an Ion 3. 22 liter ecotech
- PASSENGERS SIDE AND REAR A/C NOT WORKING INDEPENDENTLY
ORIGINAL PROBLEM WAS.COLD AIR DRIVERS SIDE HOT AIR PASSENGERS SIDE. PASSENGER SIDE CONTROL ON DASH GOT NO RESPONSE..CHANGED ACTUATOR ON…
- Replacing HVAC actuators
A few months ago, all the controls on my climate control panel went out. I can still change the fan…
- The front vents blow at floor and dash but not defrost. I have tried the relearn on your forum which will start blowing full force at windshield but after 30 sec goes back to floor and will not adjust back to windshield. I have pulled the battery which gives defrost then back to floor. The fans work fine and adjust temps and speeds but cannot get the defrost to stay. Please help
Sparky, The throttle position sensor was replaced and since then hvac will blow floor and vents but not defrost. I…
- please Bri
hello, have 2010 gmc sierra, need to remove panel/cover below ignition switch/shift lever/steering column, the one the tilt lever sticks…
- HI , i have a p0300 ignition fail in ralenti but not at 1500 or rest of rpm.We check out the 4, 02 sensors, spark plugs, maf,ignition coils,fuel pump pressure,fuel pressure regulator, we change all the fuel of the tank, but the problem continues.We have locked the fail on bank 2 cilynders( driver side). have you any idea? lator
I have a problem when i start the engine.The rpm goes to 1200rpm and after a few seconds it goes…
- 2004 Kia Optima-No Power Windows-Gauges Inop
Trying this again. I have followed your instructions. I have power to relay and module pink wire and the LED's…
- 2007 GMC Yukon XL-Poor Heat When Set Below 90 F
my 2007 Yukon heater works on 90 only
- Intermittent blower and dash lights
How does your fee structure work?
- I CAN NOT RECIEVE COMMUNICATION FROM THE ECM THRU THE DLR PLUG.
NO COMMUNICATION FROM ECM. I HAVE POWER AND 2 GROUNDS AT THE DLR PLUG. INFO LINE FROM ECM IS DEAD.…
- AC and temperature gauge do not work and drivers side vent blows hot air. If you disconnect battery and reconnect AC is fine except for drivers side vent. The AC then works for several trips and then suddenly temperatures gauge goes to 0 and AC shuts off. Interestingly pulling all of AC fuses will not rest AC , only disconnecting the battery
6 cylinder engine