This 2004 Jeep Grand Cherokee came in with the complaint that the engine would buck and jerk and sometimes stall. There was a code P0122 stored and the TPS had already been replaced in an attempt to repair this vehicle. The customer stated that the oxygen sensors and the crank position sensors had also been … Continue reading “2004 Jeep Grand Cherokee , Code P0122 Set, Runs Poorly Sometimes”
This 1998 Jeep Grand Cherokee Limited came in with the complaint that the overhead reading or map light was not working on the left side. This repair starts with removing the single front phillip’s head screw. It took me a little while to figure out how to unsnap the rear of the light assembly. I used … Continue reading “1998 Jeep Grand Cherokee, Changing The Map Light Bulbs”
This 2000 Jeep Grand Cherokee came in with the complaint that the turns signals would work sometimes. When it arrived at the shop they were not working at all. Experience tells me that it is probably a faulty flasher assembly but a few panels have to be removed to access the flasher relay. The panel … Continue reading “2000 Jeep Grand Cherokee, Turn Signals Erratic / Not Working”
This 2000 Jeep Grand Cherokee Laredo came in with the passenger front window down. The driver said she heard a pop and then the window went down. Sounds like the power window regulator cable broke. The door panel is fairly easy to remove. One phillips headed screw at the bottom of the door pull. One … Continue reading “2000 Jeep Grand Cherokee Laredo, Replacing The Right Front Power Window Regulator Assembly”
This 2006 Jeep Grand Cherokee Laredo came in with the complaint that the blower will only work on high speed. The blower resistor is located behind the glove box area. I started by removing the two 7 mm screws that attached the lower hush panel to the bottom of the dash. With the two screws … Continue reading “2006 Jeep Grand Cherokee, Blower Only Works On High”
This 1999 Jeep Cherokee came in with the complaint that the key would not turn off. I pulled it in the shop and pulled the fuel pump relay from the under hood fuse box so the engine would die. The customer had already made a mess of the steering column covers so I actually had … Continue reading “1999 Jeep Cherokee, Ignition Switch Will Not Turn Off”
This 2001 Jeep Grand Cherokee originally came in with the complaint that the blower did not work and after repairing that, I found out that the heater also would not get hot. The customer was broke, after repairing the blower fault. I was looking for something cheap to do, to get heat for this customer. … Continue reading “2001 Jeep Grand Cherokee, No Heat”
This 2001 Jeep Grand Cherokee came in with the complaint that the blower did not operate. The customer had stated that he had tried to repair it, but was unsuccessful. I had to start with installing a new harness connector for the blower speed control module under the passenger side of the dash. The customer … Continue reading “2001 Jeep Grand Cherokee, No Blower”
This 2002 Jeep Grand Cherokee came in with the complaint that the power windows had gotten to where they worked sometimes and sometimes did not. Now they mostly did not work. When I checked them they wore working but as part of my test I held one of the switches while I opened and closed … Continue reading “2002 Jeep Grand Cherokee, Power Windows Inop”