2003 Chrysler Town and Country Van came in with the complaint of the blower operates on high speed with key on and cannot be adjusted down. This procedure will also apply to Dodge Caravans with auto a/c. The controls and indicators seemed to work normally. I checked the wiring diagram and component locator and found that the blower power module is located behind the glove box. Good place to start.
After opening the glove box there are two stops the have to be depressed inward in order to drop the box down.
The blower power module is directly behind the lowered glove box. It is held in place by two 8mm hex head screws.
After removing the two attaching screws, the blower power module can be positioned for testing.
Turn the key on and while manually rotating the blower switch from low to high you should see a voltage change between about 2 volts (high)up to about 10 volts (low) on the blue/light blue wire. It is the middle wire in the left connector pictured below. Because the blower was working on high speed there was no need to do any other testing, however if you were to have low blower or no blower you would need to test further. Check for 12 volts – on the black/orange wire and 12 volts+ on the dark blue wire in the three wire connector. If either is missing check respective fuse and ground connections. Next check for 12 volts between the blue wire and the dark blue /yellow (sometimes black as pictured below) wire in the two wire connector to the right of the pictures. If either signal is missing in the two wire connector and the three wire connector tested good then the power module is faulty. If 12 volts power and ground are present then the blower motor is faulty. Usually bumping the motor with the key on and the blower switch on high will make the motor work for a little while because it will reset the worn brushes.
Three wire connector:
Black/Orange wire should have a constant ground.
Dark Blue wire should have 12 volt switched power from the front blower relay. The front blower relay is located in the Integrated Power Module (underhood fuse box).
Blue/Light Blue wire should have a varying voltage from about 2 volts(high blower command) and a nominal 10 volts(low blower command).
Two wire connector:
Check for a nominal battery voltage reading across the two wires. Key on and blower set to high.
I removed the mounting screws to gain better access to the wiring for testing.
Be careful to keep the aluminum cooling fins away from the metal brace for the glove box. It will complete the ground circuit for the blower motor and will scare you when it sparks.
Place an insulating cloth between the aluminum fins and the brace if you want.
A good look at the blower power module.
Installed the new blower power module and all is well.
As long as the constant power and ground are present at the three wire harness connector (with everything connected and switch on) the blower speed controller is faulty.
I see this is an old post, but still helpful. So my 3 lead connector looks good (blue/lt blue from 2.8V to 8.8V)
I get 12V at the two lead connector when the blower is unplugged. When I plug in the blower, I get nothing. But when I apply 12V directly to the blower from another source, it blows like a champ.
Thoughts?
I would need to have some testing data from you to be able to offer a reasonable answer. I will say however that there have been many others here that have had issues with aftermarket blower speed controllers not working properly or for very long.
I have an 02 T&C with ATC.. Replaced the Blower Power Module in June when the Blower did not function at all.. Today the blower blows on high even when I turn the head unit off.. The calibration does not reveal any issues.. Could this be a defective BPM or do I need to look at replacing the head unit.. Tried disconnecting battery for a a few minutes to no avail…
From your test data I would say the blower speed controller is faulty. If you have read through the comments, I strongly recommend a dealer part. The aftermarket ones do not last very long. Minutes to months.