This 2004 Chevrolet Impala came in with the complaint that there was no heat on the driver’s side of the car. It could very well have been the reverse, no a/c on the driver side as the problem turned out to be a faulty driver’s side blend air door actuator assembly. There was a code B0408 stored for the that actuator. If you do not have a way of checking for codes, the actuator should be watched to see if it responds to command inputs. When there is a no or poor heat condition the coolant level should always be checked first.
To access the actuator the lower dash cover has to be removed but first the cover on the left end of the dash has to come off.
Then the driver’s side hush panel.
There may be a couple of screws along the lower edge of the panel. After they are removed the cover will pull off the dash and the trunk release switch can be disconnected if present.
Four 10 mm headed screws are recessed behind the metal knee bolster and there are several 7 mm headed screws around the exterior of the panel.
You can now see the actuator in the center of the following picture. The white label is easily visible. Testing is difficult at best but here is what needs to be done if you do not have a scan tool that will interface with the system. Back probe the yellow wire and the dark blue/white wires with a voltmeter. There should be 0 volts for a stationary command. There should be a 12 volt positive for a commanded movement and a negative 12 volt reading in the opposite direction. Note that the code may have to be cleared before the control head will make the commands. Use a scan tool, disconnect the battery or remove the DIC/RKE fuse for at least 60 seconds.
This is what the actuator looks like out of the vehicle. The screws holding the actuator to the case should have 5.5 mm heads. To order this actuator please click here.
After replacement of any of the actuators a recalibration procedure needs to be performed. It is very simple though. Turn the ignition off, remove the DIC/RKE fuse from the right / passenger side, interior fuse box. It is a 10 amp fuse. Leave the fuse out for at least 60 second. Install the fuse and turn on the ignition. Do not touch the a/c controls for at least 60 seconds. switch the key off for at least 10 seconds and the recalibration will be complete when you restart the engine.
had the same problem no heat on drivers side changed the actuator did the fuse and key thing now have heat no air now what
As long as you have the needed tools and are physically capable of getting under the dash and twisting around, there should be no problem.
I have minimal mechanical skills but can do a few things. Is this job too difficult for your average Joe to tackle? Should I buy the part and have someone install it?
I followed this procedure and it worked perfectly. I didn’t check for a code or test the actuator first, so I just took a chance and replaced the actuator with a new one. The hardest part was getting the old actuator out because it is up under the dash and there’s not a lot of room to work with. Thanks for your help!!!
I just replaced one of these in a 2005 impala. It is VERY hard to remove the two screws on the actuator. I suggest filling your socket with teflon paste or something else sticky to help.
Also, I found the best position for working on this was reclining the seat and laying on it with your head under the dash. Also, you will need a 5.5 mm socket (didn’t have one), but a 7/32 inch socket works. I HAVE HEAT AGAIN!!