Re: Your 2005 Silverado Cruise Control add-in

ID Status Date Year Make Model Transmission Type A/C Controls Public/Private
#14608 Closed Silverado Auto 4l60e public

In your project here https://sparkys-answers.com/2013/08/2005-chevrolet-silverado-adding-factory.html
you mention adding it to a 4.3 truck.
Mine is a little unique. It was originally a V6/ 5 spd work truck. It now has the 5.3/4l60e with DBW from an ’05 Tahoe. The steering column is from the same Tahoe and has the CC stalk. Any advice on how to proceed? Thx.

Sparky

Do you happen to know how much of the 05 Tahoe harness was transferred to your truck?

I am assuming that you have a working electronic throttle body from the 05 Tahoe as well?

Full engine harness and under hood fuse box was transferred. Under dash harness and interior fuse box is from the 4.3/ 5 spd manual setup.

Sparky

It can be done but you may have to run wires to the PCM from the multifunction switch.  If it were in my shop I would check some cruise related data in the PCM . Next I would look  for the mating wires in the back side of the large junction block. If they are there I would next check continuity from those wires to the fuse box and the PCM. If all checked okay I would then proceed with installation of the kit.

10-4

Write a reply

The ticket has been closed. If you feel that your issue has not been solved yet or something new came up in relation to this ticket, you can re-open it by clicking this link.